Mass assignment is not restricted using attr_accessible Open
class ApplicationPlan < Plan
- Read upRead up
- Exclude checks
This warning comes up if a model does not limit what attributes can be set through mass assignment.
In particular, this check looks for attr_accessible
inside model definitions. If it is not found, this warning will be issued.
Brakeman also warns on use of attr_protected
- especially since it was found to be vulnerable to bypass. Warnings for mass assignment on models using attr_protected
will be reported, but at a lower confidence level.
Note that disabling mass assignment globally will suppress these warnings.
ApplicationPlan#clone_associations has approx 13 statements Open
def clone_associations(custom)
- Read upRead up
- Exclude checks
A method with Too Many Statements
is any method that has a large number of lines.
Too Many Statements
warns about any method that has more than 5 statements. Reek's smell detector for Too Many Statements
counts +1 for every simple statement in a method and +1 for every statement within a control structure (if
, else
, case
, when
, for
, while
, until
, begin
, rescue
) but it doesn't count the control structure itself.
So the following method would score +6 in Reek's statement-counting algorithm:
def parse(arg, argv, &error)
if !(val = arg) and (argv.empty? or /\A-/ =~ (val = argv[0]))
return nil, block, nil # +1
end
opt = (val = parse_arg(val, &error))[1] # +2
val = conv_arg(*val) # +3
if opt and !arg
argv.shift # +4
else
val[0] = nil # +5
end
val # +6
end
(You might argue that the two assigments within the first @if@ should count as statements, and that perhaps the nested assignment should count as +2.)
ApplicationPlan#default_options_for has the variable name 'v' Open
DEFAULT_CONTRACT_OPTIONS.inject({}){|memo, (k,v)| memo[k] = sprintf(v, buyer.org_name); memo}
- Read upRead up
- Exclude checks
An Uncommunicative Variable Name
is a variable name that doesn't communicate its intent well enough.
Poor names make it hard for the reader to build a mental picture of what's going on in the code. They can also be mis-interpreted; and they hurt the flow of reading, because the reader must slow down to interpret the names.
ApplicationPlan#default_options_for has the variable name 'k' Open
DEFAULT_CONTRACT_OPTIONS.inject({}){|memo, (k,v)| memo[k] = sprintf(v, buyer.org_name); memo}
- Read upRead up
- Exclude checks
An Uncommunicative Variable Name
is a variable name that doesn't communicate its intent well enough.
Poor names make it hard for the reader to build a mental picture of what's going on in the code. They can also be mis-interpreted; and they hurt the flow of reading, because the reader must slow down to interpret the names.