Mass assignment is not restricted using attr_accessible Open
class ProviderConstraints < ApplicationRecord
- Read upRead up
- Exclude checks
This warning comes up if a model does not limit what attributes can be set through mass assignment.
In particular, this check looks for attr_accessible
inside model definitions. If it is not found, this warning will be issued.
Brakeman also warns on use of attr_protected
- especially since it was found to be vulnerable to bypass. Warnings for mass assignment on models using attr_protected
will be reported, but at a lower confidence level.
Note that disabling mass assignment globally will suppress these warnings.
ProviderConstraints::Limit#initialize is controlled by argument 'limit' Open
@limit = limit || NO_VALUE
- Read upRead up
- Exclude checks
Control Parameter
is a special case of Control Couple
Example
A simple example would be the "quoted" parameter in the following method:
def write(quoted)
if quoted
write_quoted @value
else
write_unquoted @value
end
end
Fixing those problems is out of the scope of this document but an easy solution could be to remove the "write" method alltogether and to move the calls to "writequoted" / "writeunquoted" in the initial caller of "write".
ProviderConstraints::Limit#initialize is controlled by argument 'current' Open
@current = current || NO_VALUE
- Read upRead up
- Exclude checks
Control Parameter
is a special case of Control Couple
Example
A simple example would be the "quoted" parameter in the following method:
def write(quoted)
if quoted
write_quoted @value
else
write_unquoted @value
end
end
Fixing those problems is out of the scope of this document but an easy solution could be to remove the "write" method alltogether and to move the calls to "writequoted" / "writeunquoted" in the initial caller of "write".