Mass assignment is not restricted using attr_accessible Open
class SystemOperation < ApplicationRecord
- Read upRead up
- Exclude checks
This warning comes up if a model does not limit what attributes can be set through mass assignment.
In particular, this check looks for attr_accessible
inside model definitions. If it is not found, this warning will be issued.
Brakeman also warns on use of attr_protected
- especially since it was found to be vulnerable to bypass. Warnings for mass assignment on models using attr_protected
will be reported, but at a lower confidence level.
Note that disabling mass assignment globally will suppress these warnings.
SystemOperation#for calls 'ref.to_s' 2 times Open
sys_op = find_by_ref(ref.to_s)
if sys_op
sys_op
elsif DEFAULTS[ref]
- Read upRead up
- Exclude checks
Duplication occurs when two fragments of code look nearly identical, or when two fragments of code have nearly identical effects at some conceptual level.
Reek implements a check for Duplicate Method Call.
Example
Here's a very much simplified and contrived example. The following method will report a warning:
def double_thing()
@other.thing + @other.thing
end
One quick approach to silence Reek would be to refactor the code thus:
def double_thing()
thing = @other.thing
thing + thing
end
A slightly different approach would be to replace all calls of double_thing
by calls to @other.double_thing
:
class Other
def double_thing()
thing + thing
end
end
The approach you take will depend on balancing other factors in your code.
SystemOperation#for calls 'DEFAULTS[ref]' 2 times Open
elsif DEFAULTS[ref]
SystemOperation.create! :ref => ref.to_s, :name => DEFAULTS[ref]
- Read upRead up
- Exclude checks
Duplication occurs when two fragments of code look nearly identical, or when two fragments of code have nearly identical effects at some conceptual level.
Reek implements a check for Duplicate Method Call.
Example
Here's a very much simplified and contrived example. The following method will report a warning:
def double_thing()
@other.thing + @other.thing
end
One quick approach to silence Reek would be to refactor the code thus:
def double_thing()
thing = @other.thing
thing + thing
end
A slightly different approach would be to replace all calls of double_thing
by calls to @other.double_thing
:
class Other
def double_thing()
thing + thing
end
end
The approach you take will depend on balancing other factors in your code.
SystemOperation has missing safe method 'create_defaults!' Open
def create_defaults!
- Read upRead up
- Exclude checks
A candidate method for the Missing Safe Method
smell are methods whose names end with an exclamation mark.
An exclamation mark in method names means (the explanation below is taken from here ):
The ! in method names that end with ! means, “This method is dangerous”—or, more precisely, this method is the “dangerous” version of an otherwise equivalent method, with the same name minus the !. “Danger” is relative; the ! doesn’t mean anything at all unless the method name it’s in corresponds to a similar but bang-less method name. So, for example, gsub! is the dangerous version of gsub. exit! is the dangerous version of exit. flatten! is the dangerous version of flatten. And so forth.
Such a method is called Missing Safe Method
if and only if her non-bang version does not exist and this method is reported as a smell.
Example
Given
class C
def foo; end
def foo!; end
def bar!; end
end
Reek would report bar!
as Missing Safe Method
smell but not foo!
.
Reek reports this smell only in a class context, not in a module context in order to allow perfectly legit code like this:
class Parent
def foo; end
end
module Dangerous
def foo!; end
end
class Son < Parent
include Dangerous
end
class Daughter < Parent
end
In this example, Reek would not report the Missing Safe Method
smell for the method foo
of the Dangerous
module.