MainLoop::Bus#gets_nonblock has approx 7 statements Open
def gets_nonblock
- Read upRead up
- Exclude checks
A method with Too Many Statements
is any method that has a large number of lines.
Too Many Statements
warns about any method that has more than 5 statements. Reek's smell detector for Too Many Statements
counts +1 for every simple statement in a method and +1 for every statement within a control structure (if
, else
, case
, when
, for
, while
, until
, begin
, rescue
) but it doesn't count the control structure itself.
So the following method would score +6 in Reek's statement-counting algorithm:
def parse(arg, argv, &error)
if !(val = arg) and (argv.empty? or /\A-/ =~ (val = argv[0]))
return nil, block, nil # +1
end
opt = (val = parse_arg(val, &error))[1] # +2
val = conv_arg(*val) # +3
if opt and !arg
argv.shift # +4
else
val[0] = nil # +5
end
val # +6
end
(You might argue that the two assigments within the first @if@ should count as statements, and that perhaps the nested assignment should count as +2.)
MainLoop::Bus has no descriptive comment Open
class Bus
- Read upRead up
- Exclude checks
Classes and modules are the units of reuse and release. It is therefore considered good practice to annotate every class and module with a brief comment outlining its responsibilities.
Example
Given
class Dummy
# Do things...
end
Reek would emit the following warning:
test.rb -- 1 warning:
[1]:Dummy has no descriptive comment (IrresponsibleModule)
Fixing this is simple - just an explaining comment:
# The Dummy class is responsible for ...
class Dummy
# Do things...
end
Method gets_nonblock
has a Cognitive Complexity of 7 (exceeds 5 allowed). Consider refactoring. Open
def gets_nonblock
while (ch = @read.read_nonblock(1))
@buffer << ch
next if ch != MainLoop::Bus::EOL
- Read upRead up
Cognitive Complexity
Cognitive Complexity is a measure of how difficult a unit of code is to intuitively understand. Unlike Cyclomatic Complexity, which determines how difficult your code will be to test, Cognitive Complexity tells you how difficult your code will be to read and comprehend.
A method's cognitive complexity is based on a few simple rules:
- Code is not considered more complex when it uses shorthand that the language provides for collapsing multiple statements into one
- Code is considered more complex for each "break in the linear flow of the code"
- Code is considered more complex when "flow breaking structures are nested"
Further reading
MainLoop::Bus#gets has the variable name 't' Open
Timeouter.loop(timeout) do |t|
- Read upRead up
- Exclude checks
An Uncommunicative Variable Name
is a variable name that doesn't communicate its intent well enough.
Poor names make it hard for the reader to build a mental picture of what's going on in the code. They can also be mis-interpreted; and they hurt the flow of reading, because the reader must slow down to interpret the names.