mibs/junos/JUNIPER-RSVP-MIB
--
-- Juniper Enterprise specific MIB: RSVP MIB
--
-- Copyright (c) 2004, 2007, Juniper Networks, Inc.
-- All rights reserved.
--
-- The contents of this document are subject to change without notice.
--
JUNIPER-RSVP-MIB DEFINITIONS ::= BEGIN
IMPORTS
MODULE-IDENTITY, OBJECT-TYPE, Counter64, IpAddress, Unsigned32
FROM SNMPv2-SMI
DisplayString, TimeStamp
FROM SNMPv2-TC
jnxMibs
FROM JUNIPER-SMI;
jnxRsvpMIB MODULE-IDENTITY
LAST-UPDATED "200402031905Z" -- Tuesday Feb 03 19:05:42 2004 UTC
ORGANIZATION "Juniper Networks, Inc."
CONTACT-INFO
" Juniper Technical Assistance Center
Juniper Networks, Inc.
1133 Innovation Way
Sunnyvale, CA 94089
E-mail: support@juniper.net"
DESCRIPTION
"The MIB modules for Resource ReSerVation Protocol."
REVISION
"200706280930Z" -- June 28, 2007
DESCRIPTION
"Extended jnxRsvpSessionName to support names up to 64 characters"
::= { jnxMibs 30 }
-- For now, the RSVP MIB is an enterprise (Juniper Inc.) private MIB.
jnxRsvpOperation OBJECT IDENTIFIER ::= {jnxRsvpMIB 1}
jnxRsvpSessionTable OBJECT-TYPE
SYNTAX SEQUENCE OF JnxRsvpSessionEntry
MAX-ACCESS not-accessible
STATUS current
DESCRIPTION "Defines the jnxRsvpSession Table for RSVP Sessions."
::= { jnxRsvpOperation 1 }
jnxRsvpSessionEntry OBJECT-TYPE
SYNTAX JnxRsvpSessionEntry
MAX-ACCESS not-accessible
STATUS current
DESCRIPTION
"Defines an entry in the jnxRsvpSessionTable. The first index
element jnxRsvpSessionName is similar to the LSP name in the MPLS
MIB and can be used to co-relate the mplsLspEntry to an RSVP session
entry. There could be multiple entries with the same
jnxRsvpSessionName and hence the need for a secondary index which is
just an Unsigned32 to identify each of them uniquely. A management
application may walk through all entries with the same
jnxRsvpSessionName and based on the other RSVP session information in
each entry, such as jnxRsvpSessionFrom and/or jnxRsvpSessionTo may
decide to query a particular RSVP session."
INDEX { jnxRsvpSessionName,
jnxRsvpSessionIndex }
::= { jnxRsvpSessionTable 1 }
JnxRsvpSessionEntry ::=
SEQUENCE {
-- Indices
jnxRsvpSessionName DisplayString,
jnxRsvpSessionIndex Unsigned32,
-- RSVP session information for co-relation
jnxRsvpSessionState INTEGER,
jnxRsvpSessionFrom IpAddress,
jnxRsvpSessionTo IpAddress,
jnxRsvpSessionLspId Unsigned32,
jnxRsvpSessionTunnelId Unsigned32,
jnxRsvpSessionPathType INTEGER,
jnxRsvpSessionRole INTEGER,
-- MPLS stats
jnxRsvpSessionDiscontinuityTime TimeStamp,
jnxRsvpSessionMplsOctets Counter64,
jnxRsvpSessionMplsPackets Counter64
}
jnxRsvpSessionName OBJECT-TYPE
SYNTAX DisplayString (SIZE (0..64))
MAX-ACCESS not-accessible
STATUS current
DESCRIPTION "Name of the RSVP Session. This is the same as LSP name."
::= { jnxRsvpSessionEntry 1 }
jnxRsvpSessionIndex OBJECT-TYPE
SYNTAX Unsigned32
MAX-ACCESS not-accessible
STATUS current
DESCRIPTION "RSVP Session index."
::= { jnxRsvpSessionEntry 2 }
jnxRsvpSessionState OBJECT-TYPE
SYNTAX INTEGER {
up(1),
down(2) }
MAX-ACCESS read-only
STATUS current
DESCRIPTION "The operational state of the RSVP Session."
::= { jnxRsvpSessionEntry 3 }
jnxRsvpSessionFrom OBJECT-TYPE
SYNTAX IpAddress
MAX-ACCESS read-only
STATUS current
DESCRIPTION "Source IP address of this RSVP session."
::= { jnxRsvpSessionEntry 4 }
jnxRsvpSessionTo OBJECT-TYPE
SYNTAX IpAddress
MAX-ACCESS read-only
STATUS current
DESCRIPTION "Destination IP address of this RSVP session."
::= { jnxRsvpSessionEntry 5 }
jnxRsvpSessionLspId OBJECT-TYPE
SYNTAX Unsigned32 (1..65535)
MAX-ACCESS read-only
STATUS current
DESCRIPTION "LSP ID of the sender for this RSVP session."
::= { jnxRsvpSessionEntry 6 }
jnxRsvpSessionTunnelId OBJECT-TYPE
SYNTAX Unsigned32 (1..65535)
MAX-ACCESS read-only
STATUS current
DESCRIPTION "Tunnel ID for the RSVP session."
::= { jnxRsvpSessionEntry 7 }
jnxRsvpSessionPathType OBJECT-TYPE
SYNTAX INTEGER {
primary(1),
secondary(2),
unknown(3)
}
MAX-ACCESS read-only
STATUS current
DESCRIPTION
"If the head-end router signals the type of path
corresponding to an RSVP session; viz. primary or secondary
path, then this information can be used on other routers as
well to associate RSVP session information to an MPLS path
of an LSP (tunnel)."
::= { jnxRsvpSessionEntry 8 }
jnxRsvpSessionRole OBJECT-TYPE
SYNTAX INTEGER {
ingress(1),
transit(2),
egress(3)
}
MAX-ACCESS read-only
STATUS current
DESCRIPTION
"This value signifies the role of an RSVP session with
respect to the start and end points of the session. This value
MUST be set to ingress(1) at the head-end (source) of this session.
This value MUST be set to egress(3) at the tail-end (destination)
of the RSVP session. This value MUST be set to transit(2) on any
other intermediate nodes that this RSVP session exists on."
::= { jnxRsvpSessionEntry 9 }
jnxRsvpSessionDiscontinuityTime OBJECT-TYPE
SYNTAX TimeStamp
MAX-ACCESS read-only
STATUS current
DESCRIPTION
"The value of sysUpTime on the most recent occasion at which any
one or more of this RSVP Session's counters suffered a
discontinuity. The relevant counters are jnxRsvpSessionMplsOctets and
jnxRsvpSessionMplsPackets. If no such discontinuities have occurred
since the last re-initialization of the local management subsystem,
then then this object contains a zero value."
::= { jnxRsvpSessionEntry 10 }
jnxRsvpSessionMplsOctets OBJECT-TYPE
SYNTAX Counter64
MAX-ACCESS read-only
STATUS current
DESCRIPTION
"The number of MPLS octets that have been forwarded over this
RSVP Session. The number reported is not realtime, may subject to
several minutes delay. The delay is controllable by mpls statistics
gathering interval, which by default is once every 5 minutes.
If mpls statistics gathering is not enabled, this number will not
increment. Discontinuities in the value of this counter can
occur at re-initialization of the management system, and at other
times as indicated by the value of jnxRsvpSessionDiscontinuityTime."
::= { jnxRsvpSessionEntry 11 }
jnxRsvpSessionMplsPackets OBJECT-TYPE
SYNTAX Counter64
MAX-ACCESS read-only
STATUS current
DESCRIPTION
"The number of MPLS packets that have been forwarded over this
RSVP Session. The number reported is not realtime, may subject to
several minutes delay. The delay is controllable by mpls statistics
gathering interval, which by default is once every 5 minutes.
If mpls statistics gathering is not enabled, this number will not
increment. Discontinuities in the value of this counter can
occur at re-initialization of the management system, and at other
times as indicated by the value of jnxRsvpSessionDiscontinuityTime."
::= { jnxRsvpSessionEntry 12 }
END