sanger/sequencescape

A Nested Iterator occurs when a block contains another block.

Example

Given

class Duck
  class << self
    def duck_names
      %i!tick trick track!.each do |surname|
        %i!duck!.each do |last_name|
          puts "full name is #{surname} #{last_name}"
        end
      end
    end
  end
end

Reek would report the following warning:

test.rb -- 1 warning:
  [5]:Duck#duck_names contains iterators nested 2 deep (NestedIterators)

Boolean Parameter is a special case of Control Couple, where a method parameter is defaulted to true or false. A Boolean Parameter effectively permits a method's caller to decide which execution path to take. This is a case of bad cohesion. You're creating a dependency between methods that is not really necessary, thus increasing coupling.

Example

Given

class Dummy
  def hit_the_switch(switch = true)
    if switch
      puts 'Hitting the switch'
      # do other things...
    else
      puts 'Not hitting the switch'
      # do other things...
    end
  end
end

Reek would emit the following warning:

test.rb -- 3 warnings:
  [1]:Dummy#hit_the_switch has boolean parameter 'switch' (BooleanParameter)
  [2]:Dummy#hit_the_switch is controlled by argument switch (ControlParameter)

Note that both smells are reported, Boolean Parameter and Control Parameter.

Getting rid of the smell

This is highly dependent on your exact architecture, but looking at the example above what you could do is:

• Move everything in the if branch into a separate method
• Move everything in the else branch into a separate method
• Get rid of the hit_the_switch method alltogether
• Make the decision what method to call in the initial caller of hit_the_switch

Control Parameter is a special case of Control Couple

Example

A simple example would be the "quoted" parameter in the following method:

def write(quoted)
  if quoted
    write_quoted @value
  else
    write_unquoted @value
  end
end

Fixing those problems is out of the scope of this document but an easy solution could be to remove the "write" method alltogether and to move the calls to "writequoted" / "writeunquoted" in the initial caller of "write".

A method with Too Many Statements is any method that has a large number of lines.

Too Many Statements warns about any method that has more than 5 statements. Reek's smell detector for Too Many Statements counts +1 for every simple statement in a method and +1 for every statement within a control structure (if, else, case, when, for, while, until, begin, rescue) but it doesn't count the control structure itself.

So the following method would score +6 in Reek's statement-counting algorithm:

def parse(arg, argv, &error)
  if !(val = arg) and (argv.empty? or /\A-/ =~ (val = argv[0]))
    return nil, block, nil                                         # +1
  end
  opt = (val = parse_arg(val, &error))[1]                          # +2
  val = conv_arg(*val)                                             # +3
  if opt and !arg
    argv.shift                                                     # +4
  else
    val[0] = nil                                                   # +5
  end
  val                                                              # +6
end

(You might argue that the two assigments within the first @if@ should count as statements, and that perhaps the nested assignment should count as +2.)

An Uncommunicative Variable Name is a variable name that doesn't communicate its intent well enough.

Poor names make it hard for the reader to build a mental picture of what's going on in the code. They can also be mis-interpreted; and they hurt the flow of reading, because the reader must slow down to interpret the names.